Airaid 250-310 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Slide the Hump Hose and two #64 hose clamps onto
the Filter Adapter. Leave the Clamps loose at this time.
10. Install the Cool Air Box assembly into the vehicle.
Slide the airbox grommets and sleeves over the factory
studs and secure it using the nuts removed in step 3.
Hint: Lifting the washer bottle cap makes for an easier
installation.
11. Reinstall the factory ground lug through the Cool Air
Box and through the Side Bracket using one 1/4 “ Flat
Washer and the 6mm Flange Nut (#22).
12. Slide the Coupler with the #48 Hose Clamp onto
the throttlebody and one #64 Hose Clamp on the large
end. Leave the Clamps loose at this time.
18
.
Double check your work!
Make sure there is no foreign material in the intake
path. Make sure all clamps, hoses, bolts, and screws are
tight. Double check the hood clearance!
Reconnect the negative battery cable.
REV.11.18.14
14. Install the 1/4” Barbed Fitting into the Airaid Intake
Tube as shown. Transfer the Mass Air Flow meter from
the factory air box, into the Airaid Tube and secure it
using the two 8-32 x 1/2 Screws (#23). Do Not Use The
Factory Hardware.
15. Install the Airaid Intake Tube into the hump hose
first, and then into the coupler. Adjust for fit, and tight-
en all four Hose Clamps. Reconnect the PCV breather
using the supplied PCV Hose. Slide the hose onto the
factory hard line and onto the Intake Tube’s Barbed
Fitting. Use the Speed Clamp (#13) to secure the Hose
onto the Fitting. Reconnect the Mass Air Flow meter.
16. Install the Airaid Premium Filter onto the Filter
Adapter and tighten the clamp.
17. Install the Weatherstrip onto the Cool Air Box as
shown, with the contour rolling away from the Filter.
Reinstall the engine cover and oil fill cap.
#64
#64
#48
#64
Fitting
Speed Clamp
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
720-242 Airaid Oiled Media 721-242 Airaid SynthaMax Dry Media - Red
722-242 Airaid SynthaMax Dry Media - Black 723-242 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.