Airaid 250-230 User Manual
Page 2
16. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts,
and screws are tight.
17. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.12.13.13
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
11. Install the provided grommets (#15), narrow
side down, into the Airaid Intake Tube as shown.
Make sure that they are seated all the way into the
bottom of the holes.
10. Set the Airaid Premium Filter into the area in
front of the radiator. It will be mounted in step #
15.
12. Install the Airaid Intake Tube assembly onto
the throttle body first, and then align the grom-
mets over the factory grommet posts on top of
the radiator shroud. Push down on the grommets
to seat them on the posts. (Hint: Use a 1/2” deep
socket to help seat the grommets onto the posts.)
Now tighten the hose clamp on the throttle body.
14. Tighten all four button head bolts that secure
the air dams to the intake tube, and the radiator
shroud.
13. Slide one clip nut (#10) over the outside end
of the plastic radiator cover and align it with the
hole in the air dam. Install one rubber washer
(#11) over the threads of the clip nut, and then
align the air dam hole over the washer. Add one
more rubber washer, one #8 flat washer (#9), and
one M4 Pan Head Screw (#8) to secure the air
dam. Repeat this step on the passenger side. Refer
to the line drawing on page one.
Grommet Posts
15. Slide the Airaid Premium Filter up onto the
end of the intake tube and tighten the clamp. Re-
connect the MAF sensor wiring harness and re-
place the grey security clip. Reconnect the factory
breather hose to the breather fitting. Install the
weather strip (#6) onto the top of the air dams as
shown.
Synthamax Air Filters do not require
oil. Service air filter as needed by
cleaning with common non-petroleum
all-purpose household cleaner and wa-
ter. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner
to outside of air filter and allow to soak.
Then flush filter clean from the inside
out with a garden hose and repeat steps
if necessary. Do not apply high pres-
sure water or air to clean filter. Allow
filter to air dry and reinstall.
FILTER IDENTIFICATION
720-475 Airaid Oiled Media
721-475 Airaid SynthaMax Dry Media - Red
722-475 Airaid SynthaMax Dry Media - Black 723-475 Airaid SynthaMax Dry Media - Blue