beautypg.com

Airaid 250-218 User Manual

Page 2

background image

12. Double check your work!

Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight.

13. Reconnect the negative battery
cable!

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951

[email protected]

www.airaid.com

REV.12.12.13

11. Install the supplied weather strips (#7) on top of
the air dams as shown. Pull the Airaid Premium Fil-
ter up and secure it onto the Airaid intake tube with
the supplied hose clamp.

10. Install the Airaid intake tube assembly aligning
the grommets over the locating pins on the top of the
radiator shroud, and the coupler onto the MAF sen-
sor. Slide one clip nut (#11) onto the radiator shroud
with one rubber washer (#12) on the top and then
align the air dam over the M4 Clip nut. Add one
more rubber washer on top of the air dam, and then
secure it with one #8 washer (#10) and one M4 Pan
Head Screw (#9). Repeat the same procedure for the
passenger side. Now tighten the two 8-32 screws that
hold the air dams to the Airaid intake tube. Refer to
the line drawing on the first page for further clarifica-
tion. Tighten the final hose clamp on the MAF sen-
sor.

Clip Nut

Air Dam

FILTER IDENTIFICATION

720-475 Airaid Oiled Media

721-475 Airaid SynthaMax Dry Media - Red

722-475 Airaid SynthaMax Dry Media - Black 723-475 Airaid SynthaMax Dry Media - Blue

Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions

regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.

For your Oiled media filter we

suggest using the AIRAID Filter

Tune-Up Kit!

Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.

P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray

This manual is related to the following products: