Filter identification – Airaid 200-285 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Install the Airaid Premium filter onto the Filter
Adapter , and tighten the hose clamp.
10. Install the supplied Quick Connect Fittings on to the
valve cover breather fittings.
11. Connect the Barbed Fittings on the Intake tube to the
Quick Connect Fittings on the Valve covers using the 5/8
Breather hoses. The 9 1/2” Hose is to be used on the Pas-
senger side and the 12” Hose is to be on the Drivers side.
12. Reconnect the Mass Air Flow sensor.
REV.01.26.15
14. . Install the Weather Strip onto the top edge of the
Cold Air Box with the contour rolling away from the
filter.
15. Reinstall the fender brace and the rear brace bolt.
Make sure all clamps, hoses, bolts, and screws are
tight. Double check the hood clearance. Reconnect the
negative battery cable.
The CARB Decal included with this kit must be placed
in a conspicuous location under the hood in order to
pass a Smog check.
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a
new replacement label must be obtained and installed in a readily visible position in the engine compartment in
order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replace-
ment labels can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed to
any equipment which is easily detached from the vehicle. Label placement, under the hood on a painted surface is
recommended.
9 1/2” Hose
12” Hose
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and
allow to soak. Then flush filter clean from
the inside out with a garden hose and re-
peat steps if necessary. Do not apply high
pressure water or air to clean filter. Allow
filter to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!