Airaid 200-250 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.15.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
10. Install the provided coupler (#6) with two #64 hose
clamps (#14) onto the throttle body. Do not tighten the
clamps at this time.
11. Install the small end of the intake tube into the
hump hose first and then rotate it slightly to slide the
other end into coupler on the throttlebody. Adjust for fit,
and then tighten all four hose clamps.
12. Install the provided weather strip (#7) along the top
edge of the Airaid Cool Air Dam starting at the right
fender working your way around towards the radiator.
Install the Airaid Premium Filter (#1) onto the air filter
adapter and tighten the hose clamp. Reinstall the factory
beauty cover removed in step #1.. Double check your
work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance.
Reconnect the negative battery cable!
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a new replacement label must
be obtained and installed in a readily visible position in the engine compartment in order to remain CARB compliant. Failure to do so will prevent
the vehicle from passing a smog check. Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall
not be affixed to any equipment which is easily detached from the vehicle. Label placement, under the hood on a painted surface is recommended.
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
7. Remove the factory bolt that secures the right front
fender to the radiator support. It will be reused in step
#8.
8. Install the CAB assembly into the vehicle where the
factory airbox used to be using three 6mm hex bolts
(#12) and three flat washers (#11) thru the bottom. Now
reinstall the factory fender bolt thru the bracket and into
the fender. Adjust the assembly for fit and tighten all
bolts and nuts at this time.
9. Reinstall the MAF sensor and coupler onto the filter
adapter and tighten the clamp.
Next install the hump hose (#5) onto the MAF using two
#60 hose clamps (#13). Leave these two clamps loose
for now.