Reconnect the negative battery cables, Filter identification – Airaid 200-219 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.12.3.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
9. Congratulations on the successful install of your
new Airaid Intake System!
Double check your work!
Make sure there is no foreign material in the intake
path. Make sure all clamps, hoses, bolts, and screws
are tight.
Reconnect the negative battery
cables!
7. A.) Reinstall the Mass Air Flow sensor into the
Airaid Intake Tube using two 8-32x 3/8” button head
screws (#8). Do Not Use The Factory Screws!
It may be necessary to reroute the MAF sensor wir-
ing harness so that it will reach the proper location in
the tube.
B.) Next, reinstall the factory filter minder and grom-
met into the Airaid Intake Tube.
8. The Airaid Premium filter (#1) is a very tight fit in
the CAB. For ease of installation, hold the filter in
your right hand, and guide the bottom of the filter
past the flange of the tube with your left hand inside
of the CAB. It will fit! Tighten the hose clamp.
Next install the weather strip (#5) on top of the CAB,
starting at the fender and working your way towards
the radiator.
A.
B.
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a
new replacement label must be obtained and installed in a readily visible position in the engine compartment in
order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replace-
ment labels can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed
to any equipment which is easily detached from the vehicle. Label placement, under the hood on a painted sur-
face is recommended.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.