Filter identification – Airaid 200-215 User Manual
Page 2
12. Double check your work!
Make sure there is no foreign material in the intake
path. Make sure all clamps, hoses, bolts, and
screws are tight.
13. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.8.12.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
10. Reinstall the Mass Air Flow Sensor into the
Airaid Intake Tube using the supplied 8-32x1/2”
button head screws (#8).
Do Not Use The Factory Screws!
Do Not Over Tighten the screws!
Reinstall the factory grommet, and filter minder.
11. Install the Airaid Premium Filter (#1) onto the
Airaid intake tube (#4), and tighten the hose
clamp. Now install the provided weather strip (#5)
on the top of the CAD. For ease of installation,
start near the fender and work your way towards
the radiator.
WARNING! If your vehicle has a Vehicle Emission Contr ol Infor mation decal affixed to the factor y air -
box, a new replacement label must be obtained and installed in a readily visible position in the engine compart-
ment in order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check.
Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall not be
affixed to any equipment which is easily detached from the vehicle. Label placement, under the hood on a paint-
ed surface is recommended.
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require
oil. Service air filter as needed by
cleaning with common non-petroleum
all-purpose household cleaner and
water. Simple Green®, Formula
409® or equivalent works great. Ap-
ply cleaner to outside of air filter and
allow to soak. Then flush filter clean
from the inside out with a garden
hose and repeat steps if necessary. Do
not apply high pressure water or air
to clean filter. Allow filter to air dry
and reinstall.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter is reusable and should be cleaned periodically.
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!