Airaid 200-207 User Manual
Page 2
9. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
connectors, and screws are tight.
10. Reconnect the negative battery ca-
ble!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.04.21.15
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
8. Install the Airaid Premium Filter (#1) onto the Airaid
intake tube as shown, and then tighten the hose clamp.
Next, install the weather strip on top of the CAD, start-
ing at the right fender working your way towards the
front of the vehicle.
7. Connect the MAF sensor to the stainless steel coupler
and tighten the hose clamp. Install the factory grommet
removed in step #1, into the hole in the Airaid intake
tube. VERY CAREFULLY install the factory tempera-
ture sensor into the grommet.
MAF Sensor
Temp Sensor & Grommet
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a new
replacement label must be obtained and installed in a readily visible position in the engine compartment in order to
remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replacement labels
can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed to any equipment
which is easily detached from the vehicle. Label placement, under the hood on a painted surface is recommended.
FILTER IDENTIFICATION
700-422 Airaid Oiled Media
701-422 Airaid SynthaMax Dry Media - Red
702-422 Airaid SynthaMax Dry Media - Black 703-422 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.