Airaid 200-206-1 User Manual
Page 2
14. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and
screws are tight.
15. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.15.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Install the Airaid Premium Filter (#1) onto the
MAF sensor . Rotate the filter so that the tab con-
tacts the air box base, and then tighten the clamp. In-
stall the weather strip (#6) onto the top of the panel.
(Hint: Start at one end and work towards the other.)
11. Insert the Airaid Intake Tube (#2) into the hump
hose first. Then, insert the throttle body end of the tube
into the coupler. Adjust for fit, and tighten the clamps.
12. Slide one end of the 3/8” x 8” breather hose (#16)
over the barbed fitting in the Airaid Intake tube. Slide
the other end of the breather hose onto the metal tube
on the engine.
10. Insert one ¼” NPT x 3/8” barbed fitting (#15) into
the Airaid Intake Tube (#2).
Tab
WARNING! If your vehicle has a Vehicle Emission Contr ol Infor mation decal affixed to the factor y air -
box, a new replacement label must be obtained and installed in a readily visible position in the engine compart-
ment in order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check.
Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall not be
affixed to any equipment which is easily detached from the vehicle. Label placement, under the hood on a paint-
ed surface is recommended.
FILTER IDENTIFICATION
720-477 Airaid Oiled Media 721-477 Airaid SynthaMax Dry Media - Red
722-477 Airaid SynthaMax Dry Media - Black 723-477 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.