Airaid 200-167 User Manual
Page 2
14. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and
screws are tight.
15. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.13.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Install the Airaid Premium Filter (#1)
onto the filter adapter, and tighten the hose
clamp. Install the weather strip (#8) onto the
Airaid Cool Air Dam. Reconnect the MAF
sensor wiring harness. (Note: Start from one
corner and work your way around to insure
proper alignment of the weather strip.)
10. Install the urethane hump hose (#6) and
two #72 hose clamps (#16) onto the large end
of the Airaid intake tube. (Note: Leave hose
clamps loose until final assembly.)
11. Install the urethane coupler (#7) and two
#60 hose clamps (#17) onto the small end of
the Airaid intake tube. (Note: Leave hose
clamps loose until final assembly.)
12. Install the Airaid intake tube assembly
onto the engine. Install the hump hose end
onto the filter adapter first and then slip the
coupler end of the tube onto the aluminum
intake tube. Adjust for fit, and tighten the hose
clamps. (Note: There should be a gap in be-
tween the Airaid intake tube and the air filter
adapter.)
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a new replacement label must
be obtained and installed in a readily visible position in the engine compartment in order to remain CARB compliant. Failure to do so will prevent
the vehicle from passing a smog check. Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall
not be affixed to any equipment which is easily detached from the vehicle. Label placement, under the hood on a painted surface is recommended.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
FILTER IDENTIFICATION
700-469 Airaid Oiled Media
701-469 Airaid SynthaMax Dry Media - Red
702-469 Airaid SynthaMax Dry Media - Black 703-469 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.