Airaid 200-146 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.11.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or
instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during
shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive
through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.
12. Install the provided urethane hump hose (#7)
onto the Airaid Modular Intake Tube (MIT) (#5)
with the 2 supplied #60 hose clamps (#11). Note:
Leave hose clamps loose until final assembly.
15. Double check your work!
Make sure there is no foreign material
in the intake path. Make sure all
clamps, hoses, bolts, and screws are
tight
.
16. Reconnect the negative battery
cable!
13. Connect the Airaid MIT (#5), hump hose
end first, to the MAF sensor, and then connect
the other end of the tube assembly to the throt-
tle body. Check for interference and adjust the
MIT accor dingly, and then tighten the hose
14. Re-install the factory filter minder and rub-
ber grommet into rear of Airaid MIT. Re-install
the beauty cover from step 2.
10. Install the MAF sensor to the filter
adapter (#4), and tighten the hose clamp .
11. Install the provided coupler with clamp
(#6) onto the Airaid Modular Intake Tube
(MIT) (#5).
WARNING! If your vehicle has a Vehicle Emission Contr ol Infor mation decal affixed to the factor y airbox, a new replacement label must be obtained
and installed in a readily visible position in the engine compartment in order to remain CARB compliant. Failure to do so will prevent the vehicle from passing
a smog check. Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed to any equipment which
is easily detached from the vehicle. Label placement, under the hood on a painted surface is recommended.
FILTER IDENTIFICATION
700-469 Airaid Oiled Media 701-469 Airaid SynthaMax Dry Media - Red
702-469 Airaid SynthaMax Dry Media - Black 703-469 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.