AEC FSS Series 1.5- 10 HP Fountain Solution Systems - Manual (Page 4)

FSS Series Fountain Solution Systems Page 3
IAE-600
Safety Considerations
AEC/FSS Solution Systems are designed to provide safe and
reliable operation when installed and operated within design
specifications, following national and local safety codes.
To avoid possible personal injury or equipment damage when
installing, operating, or maintaining this equipment, use good
judgment and follow these safe practices:
; Follow all SAFETY CODES.
; Wear SAFETY GLASSES and WORK GLOVES.
; Disconnect and/or lock out power before servicing or
maintaining the chiller.
; Use care when LOADING, UNLOADING, RIGGING, or
MOVING this equipment.
; Operate this equipment within design specifications.
; OPEN, TAG, and LOCK ALL DISCONNECTS before
working on equipment. You should remove the fuses and carry
them with you.
; Make sure the chiller and components are properly
GROUNDED before you switch on power.
; When welding or brazing in or around this equipment, make
sure VENTILATION is ADEQUATE. PROTECT adjacent
materials from flame or sparks by shielding with sheet metal.
An approved FIRE EXTINGUISHER should be close at hand
and ready for use if needed.
; The refrigeration system can develop refrigerant pressures in
excess of 500 psi (3,447.5 kPa/ 34.47 bars). DO NOT CUT
INTO THE REFRIGERATION SYSTEM. This must be
performed by a qualified service technician only.
; Do not restore power until you remove all tools, test
equipment, etc., and the chiller and related equipment are fully
reassembled.
; Only PROPERLY TRAINED personnel familiar with the
information in this manual should work on this equipment.