AEC OS Series Gravimetric Batch Blenders - Manual (Page 82)

Page 81 of 118
Batch Printout
If you wish to print out the inventory information on a batch
interval basis, then simply enter in the desired batch interval
and the printouts will occur each time that the number of
batches programmed is produced. To set the batch interval,
press to change, enter the number of batches
between printouts, and press the key.
5-8-28-2 Entering the Job Number
Some applications call for tracking a job number. The OS/OA
System will provide this by allowing the operator to assign a
job number. This job number may be up to eight digits long. It
is held in memory and will be printed out on each and every
batch ticket until it is changed to the next job number. This
number is simply a reference number for the operator, or
management.
5-8-28-3 Print Inventory
The print inventory menu item is used to produce on demand,
inventory printouts. Before selecting this item, be sure that the
printer is properly connected and ready. This function will
generate an inventory printout with the current date and time
information.
5-8-28-4 Display Time and Date
The display Time and Date item on the printer menu is used to
verify the current time and date information.
5-8-28-5 Set Time
The Set Time item located in the printer menu allows the
operator to set the OS/OA’s internal time clock. The clock data
must be entered in the traditional:
HH = Hours
MM = Minutes
SS = Seconds
5-8-28-6 Set Date
The Set Date item located in the printer menu allows the
operator to set the OS/OA’s time clock’s date. This internal
clock must be entered in the traditional:
MM = Month
DD = Day
YY = Year (last 2 digits)