AEC OS Series Gravimetric Batch Blenders - Manual (Page 24)

Page 23 of 118
Safety 2
2-1 Work Rules
Install, operate, and maintain this equipment according to applicable work and
safety codes for your location. This includes OSHA, CE, NEC, CSA, SPI, and
many other local, national, and international regulations. Obey these specific
work rules:
Read and follow the instructions in this manual before installing, operating, or
maintaining any equipment. Additional copies are available from AEC, Inc.
Only qualified persons should work on, or with, this equipment.
Work only with approved tools and devices.
Disconnect and lock out power while working on this equipment.
2-2 Tools and Equipment Needed
You’ll need the following:
• Hand tools
• Fork lift or overhead lift
• Wire, conduit, and fittings for wiring runs (if receptacle is not already in
place)
• Mounting bolts with nuts and washers
• Compressed air tubing and fittings
2-3 Mechanical Installation
Blenders may be mounted on the machine, a stand, or a mezzanine. Be sure it is
securely attached and additional bracing is used if necessary. The sections on
the following pages explain general installation rules.
Read manual thoroughly before installing
blender.
Use approved safety straps or chains to lift the
blender at the marked lifting points.