AEC OS Series Gravimetric Batch Blenders - Manual (Page 117)

Page 116 of 118
12 Appendix
Important!
Hidden, programmable switches and hidden menu pages should
not be made available to floor operators. These pages include the
Service Supervisor Information addendum located in this section.
Unauthorized changes to these factory settings by inexperienced
operators may prevent the OS/OA unit from operating properly,
and may void part or all of the warranty.
12-1 Addendum Service Supervisor Information
Note: Should not be used by untrained personnel – blender
controller and/or program can be compromised!
12-1-1 Programmable Switches
OS/OA
The OS/OA Series blender software program has been designed to
allow some customizing to achieve certain desired operating
parameters. The following is a listing of the selections that are “field”
programmable, followed by the procedure for doing so.
This menu is entered by pressing the <0> key when in the
“Diagnostics” menu.
Enter the long password “3145348” and press . The factory
setup section displays. Press the key for the display
similar to that shown below and use the keystrokes described herein to
change or toggle the parameters.
LDC#2 MENU Lbs PRTR:ON
LKR BRDY HPR