Replace the disk, E replace the disk, Gnr-3000 system administrator’s manual – ACTi GNR-3000 V3.0.09 User Manual
Page 37
GNR-3000 System Administrator’s Manual
2.
Remove the failed disk from the bay and install a new one, following the steps in Hard
Disk Installation on page 19.
3.
The mirrored volume has now become a simple volume. Right-click on this volume and
select “Add Mirror…,” select the new disk and then click “Add Mirror”.
4.
This volume will start Volume Resynchronization immediately. During this period, the
recording will proceed normally. The status will turn Healthy after the Resyching is
complete.
Replace the Disk
To replace a failed disk:
1.
On Disk list, right-
click the failed disk and select “Offline”.
2.
Shut down this unit and install the new disk following the steps in Hard Disk Installation on
page 19.
3.
After restarting this unit, enter Disk Management, right-click on the failed volume and
select “Delete Volume”. For how to delete the volume using the command line, you may
refer t
provided by
Microsoft TechNet for more details.
4.
After the, volume is deleted, you may now build a new volume using the available disks.