Welltech VoIP ATA series V.303 User Manual
Page 97
ATA Web user guide
Welltech Technology Co., Ltd.
97 / 114
2015/1/8
Item Decription
Type 1 (
)
Type 2 (
* Your Register Proxy server must support this function.
Management
form WAN
Default is Enable; ATA allow web management via WAN port.
Disable: ATA only allow web access vial LAN port.
Option: Disable, Enable
Stop Feature
Tone
Default is Disable
Enable: If you enable [Subscribe for MWI, forward, DND]
function, you will hear the alert tone when you pick up the
phone.
Option: Disable, Enable.
Billing Signal
Default is Disable.
Option: Disable, Polarity Reversal, Tone_12K, Tone_16K.
CPC Delay
Default: 2(sec)；Setting how long it takes for the voltage reaches
0V when receiving hang up signal. Only numbers are accepted,
data range (2~5 sec.), maximum length: 1 byte.
CPC Duration
Default: 120ms. Setting how long it takes for the voltage
reaches 0V, data range (0~120), maximum length: 3 bytes.
IP Dialing Format Default is Type 1 (
); Define the IP dialing format.
Option: Disabled, Type 1 (
.), Type 2 (x.x.x.x)
Send Flash event Default is Disable; When you press [Hook/Flash (Transfer)] ATA
will send different event.
Option:
Disable: [SIP/DSP, Content-Type=applicatio-sdp]
DTMF Event: [RTP event, Payload type=RTP event Flash]
SIP Info: [SIP, Request: INFO sip:xxx@xxxx]
Encrypt Type
Default is Disable.
Option: Disable, INFINET, AVS, WALKERSUN1, WALKERSUN2,
CSF1, CSF2, GX, VGX, RC4, VOS_R,
VGCP and Welltech
.
* Your Register Proxy server must support this function.
Encrypt Key
Set encryption password。Only support GVX encryption format,
maximum data: 63 bytes.
PPPoE Retry
Period
Default: 5 (Seconds)； Set up how long it takes for PPPoE to
retry when PPPoE failed. Only numbers are accepted, data
range: (5~255), maximum length: 3 digits.
System Log
Server
Sending ATA debug message to System Log Server which can be
an IP Address or Domain Name Address. Format:
xxx.xxx.xxx.xxx; Maximum length: 63 digits.
System Log Type Default is Disable; Define Syslog type and Log messages.
Option: Disable, Call Statistics, General Debug, Call Statistics +
General Debug, SIP Debug, Call Statistics + SIP Debug, General
Debug + SIP Debug, All.
FXO Port Coutry
Default is USA country telephony specification. To select FXO
Port impedance of the analog telephone by different countries.
FXO Silence Time Default to 30 minutes. Configure FXO silence time setting to
release FXO port automatically. Time length is 1 to 250 minutes.
FXO CID forward Default is Disable. When FXO port received an incoming call, ATA
will forward this call as well as caller ID to IP side. Go to
webpage configuration to enable the setting at
[Phone –