Welltech VoIP ATA series V.303 - Manual (Page 31)

ATA Web user guide
Welltech Technology Co., Ltd.
31 / 114 2015/1/8
Item Decription
row) .
DND Time of
phone 2 This command is to configure DND time period at phone 2.
Default is
From 0:0(start time) To 0:0(end of time) . The time
format is 24 hours system (hh/mm, Hours/Minutes). Each field
has 2 digits number only.
Alarm Type of
phone 1 Default is Disable. Configure Phone 1 alarm function. When you
set to enable, phone 1 will Ring according to
pre-configured (see
next row how to configure alarm time) alarm time . The alarm
Ring last for 1 minute. To cancel alarm setting, simply pickup
handset and hand up. The default ring time is 1 minute.
Alarm Time for
phone 1 Default is 0:0(Hour/Minute). The time format is 24 hours
system(hh/mm). Each field allows to enter 2 digits number only.
Alarm Type of
phone 2 Default is Disable. Configure Phone 2 alarm function. When you
set to enable, phone 2 will Ring according to
pre-configured (see
next row how to configure alarm time) alarm time . The alarm
Ring last for 1 minute. To cancel alarm setting, simply pickup
handset and hand up. The default ring time is 1 minute.
Alarm Time for
phone 2 Default is 0:0(Hour/Minute). The time format is 24 hours
system(hh/mm). Each field allows to enter 2 digits number only.
Submit Save the configuration.
Figure 3: FXS+FXO, ATA-171M device.
(Figure 3)
Item Decription
Forward Type of
phone1 Default is Disable. To configure Phone 1 forward type.
Here provides 5 options: Disable, All (unconditional), Busy, No
Answer, Busy or No Answer.
NOTE：Please make sure your service provider support this
forward function.
Forward Number To configure Phone 1 forward number, simply dial [number or