Welltech WellGate M1 - Manual (Page 45)

WellGate M1 Web user guide
Welltech Technology Co., Ltd.
45 / 58 2014/12/1
9.5 Advanced
9.5.1 Function
Provide anonymous call, billing signal, encryption, syslog and detail parameter
function setting.
9.5.2 Instruction
(Figure 1.)
Item Description
ICMP Not Echo Default: Disable; When this function was set up “Enable”, this
device will not responseto the message of ping.
Provide options: Disable, Enable.
Anonymous Call Default: Disable; When this function was set up Type 1/Type 2,
this device will use the anonymous Caller ID.
Provide options: Disable, Type 1
( [email protected] ), Type 2
( [email protected]) 。
*This function must be supported from SIP Server.
Management
from WAN
Default: Enable; Allow users login system from WAN Port.
When this function was set up Disable, users can only login this
device from LAN Port.
Provide options: Disable, Enable.
WEB Login Port Default: 9999. Set up web login port location. This column can
only enter numbers; maximum length is 5 bytes with a range of
1~65535.
Telnet Login Default: Enable; Allows using Telnet to login system. If the
setting is disable, User can’t use Telnet to login this device.
Provide drop-down options: Disable, Enable.
IP Dialing Format Default: Type 1 ( [email protected] ); When this function was set up
Disable, this device can not dial IP.
Provide options: Disabled, Type 1 ( [email protected] .), Type 2 (x.x.x.x).
Send Flash event Default: Disable; Send the type of call waiting.