Welltech WellGate M1 - Manual (Page 4)

WellGate M1 Web user guide
Welltech Technology Co., Ltd.
4 / 58 2014/12/1
1.
Introduction
This user’s manual is ATA GSM system for ATA series GSM VoIP terminal adapter. This
user’s manual explains web configuration, and command line configuration for
WellGate M1. Before using this device, some setup procedures are required to make
the M1 GSM gateway work properly. Please refer to the “Instruction of Web
Environment” for further information.
2. Hardware Overview
The WellGate M1 GSM gateway has the following interfaces: Network, GSM SIM card
interface, LED indication, and power connector.
2.1 Two RJ-45 Network interface
These two interfaces support 10/100Mbps Fast Ethernet. You can connect WAN
RJ-45 Fast Ethernet port to the ADSL or Switch, and connect the LAN port to your
computer.
2.2 One GSM SIM card interfaces.
You can connect a GSM SIM card into the card try by pushing SIM card to lock. And
push SIM card again to eject SIM card.
2.3 LED Indications
There are three LED indicators on the GSM ATA to show the Power, GSM system, SIP
domain Register, WAN, and LAN status.
2.4 Rear Interface Descriptions
This is front panel printing and LED indications.
Item Description
WellGate M1 Device model name.
Power Power status. Power ON is light.
WAN
Shows device WAN port status. When WAN port connects
successfully, the LED will light up.
LAN Shows device LAN port status. When LAN port connects
successfully, the LED will light up.
Status Shows SIP domain account register status. When the SIP account
registed to SIP Server completely, the LED will light up. When this
device was used in P2P mode, this LED is OFF.
GSM Shows SIM card of GSM gateway status if it connects to GSM Base
Station successfully. Once GSM gateway registered to GSM BTS
completely, the LED will light up.