Visara iCON-XT Installation - Manual (Page 7)

707097-001 1-1
Chapter 1. Safety Information and
Technical Specifications
Electrical Safety Guidelines
Warning: To avoid electrical chock, check the power cords as follows:
Checking the Power Cords
• Use the exact type of power cords as required.
• Be sure to use power cord(s) that came with safety certifications.
• The power cord(s) must be compliant with the AC voltage requirements in
your region.
• The power cord plug cap must have an electrical current rating that is at least
125% of the electrical current rating of this product.
• The power cord plug cap that plugs into the AC receptacle on the power supply
must be an IEC 320, sheet C13, type female connector.
• Be sure to disconnect the power supply before accessing the server or its
components.
• Plug the power cord(s) into a socket that is properly grounded before turning
on the power.
Warning: Follow the guidelines below to avoid possible damages to the system or
injury to yourself.
General Electrical Safety Guidelines
• Be aware of the locations of the power switches on the chassis and in the room,
so you can disconnect the power supply if an accident occurs.
• Take extra precautionary measures when working with high voltage components.
It is not recommended to work alone.
• Before removing or installing main system components, be sure to disconnect
the power first. Turn off the system before you disconnect the power source.
• Use only one hand when working with powered-on electrical equipment to
avoid possible electrical shock.
• Use rubber mats specifically designed as electrical insulators when working
with computer systems.
• The power supply or power cord must include a grounding plug and must be
plugged into grounded outlets.
• Motherboard Battery: CAUTION - Make sure not to install the onboard
battery upside down to avoid possible explosion. Make sure that the positive
side is facing up on the motherboard. This battery must be replaced only with
the same or an equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer's instructions.
• CD-ROM Laser: CAUTION - To avoid injury do not open the enclosures of
power supplies or CD ROM.