Visara iCON-XT Installation - Manual (Page 30)

3-8 707097-001
ICON-XT Server - Installation and Maintenance Manual
Installing a new power supply:
Replace the failed power supply unit with an identical unit.
1. Push the new power supply unit into the power bay until you hear a click.
2. Secure the locking tab on the unit and finish by plugging the AC power cord back
into the unit.
CD-R/W Drive
Removing/Installing CD-R/W Drive
The CD-R/W drive is located in the upper 5.25" bay on the front of the chassis. This
component is not hot-swappable, meaning system power must be turned off before
removing and installing it.
To remove the drive:
1. Power down the system and then remove the top cover of the chassis.
2. Disconnect the IDE interface ribbon cable and the power connector from the unit.
3. Push the latch located at the rear of the CD-R/W drive bay then push the drive out
through the front of the chassis.
4. Remove the guide plates from the failed drive and install them making sure that the
arrows on both the right and the left sides are facing up. Attach the component to
the carrier if installing.
Reverse this procedure to install the drive, making sure the latch clicks when reinserting
the CD-R/W drive into the chassis. Replace the top cover when finished.