Visara iCON-XT Installation - Manual (Page 31)

Chapter 3. Maintenance
707097-001 3-9
Floppy Drive Removal/Installation
This component is not hot-swappable, meaning system power must be turned off before
removal and installation.
To remove the drive:
1. Power down the system and then remove the top cover of the chassis.
2. Disconnect the HDD interface ribbon cable and the power connector from the unit.
3. Push the latch located at the rear of the floppy drive bay and push the drive out
through the front of the chassis. The illustration shows how to remove the drives
and how to mount each drive on the rails, which are needed to slide them into the
open chassis bays.
Reverse this procedure to reinstall the drives, making sure the latch clicks when reinserting
the drive bay into the chassis. Replace the top cover when finished.
Note: The red wire on a ribbon cable typically designates the location of pin 1.