Visara SCON-25L Reference Manual - Manual (Page 47)

Chapter 4. Assembly Removal/Replacement
707028-007 4-5
Floppy Disk Drive
Removal
1. Ensure power is off. Remove the cover.
2. Locate and disconnect the drive signal and power supply cables.
3. Remove the four screws attaching the disk drive to its bracket. There are two
screws located on each side of the drive bracket.
4. Carefully slide the drive from its bracket.
Replacement
1. Align the disk drive into its mounting track.
2. Carefully slide the disk drive into its bracket.
3. Install the screws to attach the drive to the bracket.
4. Connect the drive signal and power supply cables.
5. Replace the cover carefully, using the Main Cover Replacement procedure
described above. You may have to reposition the disk drive to align it with the
cover properly.
Hard Disk Drive
The hard disk drive is installed below the floppy drive. Note that older platforms
use a SCSI hard disk, while newer platforms use an IDE hard disk with a SCSI to
IDE adapter mounted to it.
Removal
1. Ensure power is off. Remove the cover.
2. Remove the floppy disk drive assembly.
3. Remove the SCP and any other boards required to provide space for hard disk
drive removal from the unit.
4. Locate and disconnect the hard disk drive signal, fan and power supply cables.
5. Remove the four screws attaching the hard disk drive to its bracket. There are
two screws located on each side of the drive bracket.
6. Carefully slide the drive from its bracket.