Visara SCON-25L Reference Manual - Manual (Page 43)

707028-007 4-1
Chapter 4. Assembly Removal/
Replacement
Introduction
All members of the 25S/25L/28L/3074 family utilize the same chassis. The following
procedures describe removal/replacement of assemblies that may be installed in
the 25S/25L/28L/3074 unit.
Prior to any removal or replacement procedure, make sure the unit is turned OFF
and the power cord is disconnected from the AC wall outlet.
WARNING
Due to electrical hazard, do not remove the system cover. Only qualified service
personnel may remove the system cover for service or installation of circuit
cards.
Assembly Drawing
Slot Cover
Male SCSI Term
Backpanel PCB
SCP PCB
EBP-C PCB
3.5” FDD
Diskette Holder
Operator Panel
Power Supply
Hard Drive
OPBA PCB
OP MTG BKT