Visara SCON-25L Reference Manual - Manual (Page 38)

SCON-25L/28L/3074 Console Concentrator
1174-25S Communications Server Hardware Reference Manual
3-6 707028-007
• Operator panel LCD.
• Operator panel check light.
• Printed circuit board LEDs.
• Box$fail.txt file in system directory of hard drive.
IML Errors (ERR___)
Initial Machine Load (IML) occurs when the unit is turned on, or when the IML
key on the operator panel is pressed. During IML, the unit executes a series of tests
that checks the machine’s ability to operate.
An IML error message displays as ERR XXX* on the operator panel, where
ERR indicates the occurrence of an IML error.
XXX is the IML state in which the error occurred.
* indicates that additional messages are available that describe the error (not always
present).
IML errors and possible recovery are described in the LINCS Problem Determination
Manual, “IML States and Errors.”
IML errors are logged into the box$fail.txt file.
Exception Errors (XCP___)
Exception errors are detected by a processor and occur during IML. Exception
errors are nonrecoverable and require recording the error information and then
IMLing the unit to resume operation.
Exception error messages look like this on the operator panel:
XCP JSS:BB:EEE*
where:
XCP indicates an exception error.
JSS indicates the physical slot number of the board where the error occurred or
was identified.
BB shows the board ID in hexadecimal format.
EEE shows the type of exception error.
* indicates additional messages that give more information about the error (not
always present).
The LINCS Problem Determination Manual contains additional information about
exception errors.