Visara SCON-25L Reference Manual - Manual (Page 11)

707028-007 2-1
Chapter 2. Installation
Installation Checklist
The following is a brief checklist of typical installation tasks. Detailed information
is provided later in this chapter.
1. Check the shipping carton for any obvious shipping damage prior to unpacking.
2. Unpack the unit per instructions provided with the shipping carton. This unit
weighs in excess of 50 lbs., so please take any necessary precautions such as
seeking help with lifting.
3. Place the unit in an appropriate location. Refer to “Environmental Parameters.”
4. Remove the cardboard protector (if present) from the disk drive. The unit
should not be powered on with a cardboard protector in the disk drive or the
disk drive may be damaged.
5. Inspect the unit for any physical damage.
6. Install (if required) and connect 3270 COAX, ESCON, Local Channel, Token
Ring, RS232, V.35 and/or Ethernet cables as needed.
7. Ensuring that the Power switch on the front of the unit is off, plug the unit into
an appropriate AC outlet.
8. Turn the unit on (see Chapter 3, “Operation”). After a few seconds, messages
will appear on the LCD of the Operator Panel. These messages will change as
the unit proceeds through various IML states until it has completed the boot
up procedure. When the boot has completed, the word ‘CONFIGURATION’
should appear on the LCD. This initial boot process should take a few minutes
(less than 10). If the boot process has not completed, or if you see a message
that begins ‘ERR’ or ‘XCP’, then a failure of the boot process has occurred. If
a failure of the boot process occurs, you will want to contact your Service
Provider or the Visara Intellicenter for assistance. Removal of the covers by
unauthorized persons can void your warranty.
9. Configure the unit for use (see the LINCS Planning, Configuration, and Central
Control Manuals).