Visara SCON-25L Reference Manual - Manual (Page 33)

707028-007 3-1
Chapter 3. Operation
Controls
The power switch is located below the operator panel. Set the switch to the On (|)
position to turn on power, and set the switch to the Off (O) position to turn off
power. See Figure 3-1.
The operator panel is used to enter, select, or change modes of operation.
The 25S/25L/28L/3074 unit contains a hard drive and floppy diskette drive for
data storage.
Operator Panel
Power Switch
Flopy Disk Drive
Figure 3-1. 25S/25L/28L/3074 Unit
Operator Panel
The operator panel is shown in Figure 3-2.
Indicators
Located on the operator panel are an LCD display and LEDs that indicate some of
the operational states of the unit.
Diag - Lights when the controller is in Offline Diagnostics mode. Customer service
representatives use this mode.
Config - Lights when the 25S/25L/28L/3074 is IMLed onto the default
configuration, or if no saved configuration is present. This is the normal condition
for a unit fresh from the factory, booted for the first time.