Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 68)

60 A PPENDIX A: SNMP A GENT
ddsDteRate19200 - 19200bps
ddsDteRate38400 - 38400bps
ddsDteRate52000 - 52000bps
ddsDteRate54000 - 54000bps
ddsDteRate56000 - 56000bps
ddsDteRate57600 - 57600bps
ddsDteRate60000 - 60000bps
ddsDteRate62000 - 62000bps
ddsDteRate64000 - 64000bps
ddsDteFormat (read-write)
This variable describes the current operations format of the DTE interface. Only
the ddsDteFormatSync applies if ddsNetMode is DDS-I or DDS-II.
ddsDteFormatSync(1) - DTE interface is currently set to operate in
Synchronous clocking format
ddsDteFormatAsync(2) - DTE interface is currently set to operate in the
Asynchronous clocking format
ddsDteFormatNotAvail(3) - DTE interface operating format is not available
ddsDteParity: (read-write)
Allows you to verify or select parity for the DTE interface. This variable is only
valid when the DTE Mode is set to ASYNC. For the PRISM 41TDM, the value
always returns ddsDteParityNotAvail. This value cannot be modified.
ddsDteParityNone(1) - DTE interface is currently set for no parity bit
checking or generation
ddsDteParityOdd(2) - DTE interface is currently set for odd parity
ddsDteParityEven(3) - DTE interface is currently set for even parity
ddsDteParityMark(4) - DTE interface is currently set for mark parity
ddsDteParitySpace(5) - DTE interface is currently set for space parity
ddsDteParityNotAvail(6) - Parity setting on the DTE interface is not available.
ddsDteStopBit: (read-write)
Allows you to verify or set the stop bit setting for the DTE interface. This variable
is only valid when the DTE interface is set to ASYNC. For the PRISM 41TDM,
the value always returns ddsDteStopBitNotAvail. This value cannot be modified.
ddsDteStopBit1(1) - DTE interface is configured to operate in the ASYNC
mode with 1 stop bit
ddsDteStopBit2(2) - DTE interface is configured to operate in the ASYNC
mode with 2 stop bits