Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 53)

Configuration 45
the ISDN switch type and version. Then, enter the TEI, SPID, and directory
number information supplied by the ISDN service provider. The PRISM 41TDM
uses this data to generate the correct AT commands for the DBU Configuration
screen Reset fields.
This screen is only available if an internal ISDN terminal adapter is installed in the
unit.
Internal ISDN Module Access
This command is used only by Verilink service personnel when troubleshooting
problems in the field. It is not user accessible.
TCP/IP
Configuration
The TCP/IP Configuration screen (Figure 4-11) is accessible for the SLIP, Ethernet
or Token Ring interface. It allows for the entry of those parameters required for
proper operation with an Ethernet or Token Ring-based LAN manager.
Figure 4-11 TCP/IP Configuration Screen
Element
This field allows reviewing and modifying the TCP/IP addresses for the near-end
or far-end unit. The screen position on either unit is independent. If the unit is in
the DTE Port Parameters screen on the near-end unit, toggling the Element to Far
displays the last screen accessed on the far-end unit such as the Main Menu,
Utilities, Configuration, or Summary screen.
Reset LAN Interface
For changes to take effect, the LAN interface must be reset or the parameters must
be stored to the EEPROM. Selecting this field opens a confirmation screen which
prompts proceeding with the reset.
Selecting the Reset LAN Interface command disrupts data service.
✍