Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 58)

50 C HAPTER 4: T ERMINAL I NTERFACE
Direct- Sends traps directly to the SLIP server.
Primary Dial String
This field is an ASCII string for the primary call on alarm telephone number used
in the DIAL mode. This string must include the ATDT command prefix (ex.
ATDT555-1212). The unit attempts three times to connect using the primary
number. If these attempts fail, it makes three more attempts using the secondary
number (if it is not blank). If the secondary number fails, the unit waits five
minutes and re-attempts to communicate with the primary number. If a connection
is not made, the unit sends a notification message and then disconnects.
Secondary Dial String
This field is an ASCII string for the secondary call on alarm telephone number
used in the DIAL mode. This string must include the ATDT command prefix (ex.
ATDT555-1212). If the unit did not connect using the primary number, it makes
three attempts to connect using the secondary number (if it is not blank). If the
secondary number fails, the unit waits five minutes and re-attempts to
communicate with the primary number. If a connection is not made, the unit sends
a notification message and then disconnects.
Initialization String
The modem initialization string is entered in this field. Refer to the modem’s
documentation for further information. The default setting is ATE1Q01V1S0=1.
Disconnection String
This field identifies the character string to be output when the modem session is
terminated. The default setting is ATH.
Compressed SLIP
The choices are Auto, Disable, and Enable. The Auto setting allows the unit to
negotiate with the far end to enable or disable SLIP compression, depending on the
type of connection.