Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 66)

58 A PPENDIX A: SNMP A GENT
ddsNetModeProprietary(2) - Data being sent out on the DDS network is in a
proprietary mode to allow for remote communications, rate adaption, SYNC to
ASYNC modes, and/or TDM modes.
ddsNetMode64KClearChannel(3) - A special case of DDS-II, where the line
rate is 72K, the data rate is 64K, and there is no secondary channel.
ddsNetMode64KCCProprietary(4) - A special case of DDS-II, where the line
rate is 64K, and there is no secondary channel. In addition, the data being sent
out on the DDS network is in a proprietary mode to allow for remote
communications, rate adaption, sync to async, and/or TDM modes.
ddsNetSendCode: (read -write)
This variable describes what type of test code is being sent from the DDS unit
back towards the network.
ddsNetSendNoCode(1) - Normal data mode of operation
ddsNetSendOtherTestPattern(2) - Sending some other stress pattern than 511
ddsNetSend511Pattern(3) - Sending 511 stress pattern toward the network
ddsNetLoopConfig: (read-write)
This variable allows you to set or view the current loop state of the DDS network
interface.
ddsNetNoLoop(1) - Normal data mode of operation
ddsNetLocalLoop(2) - Data is looped back toward the DDS network switch
activated loop
ddsNetLineLoop(3) - Data is looped back toward the DDS network sealing
current activated loop
ddsNetOtherLoop(4) - Other loop than listed above is active
ddsNetFarEndLineLoop(5) - Far end unit currently has a line loop active
ddsNetStatus: (read-only)
Reports current operational status of the network interface
ddsNetNoAlarm(1) - DDS network interface has no current alarms
ddsNetLOS(2) - DDS network interface has Loss Of Signal
ddsNetOOS(3) - DDS network interface is receiving Out Of Service codes
ddsNetOOF(4) - DDS network interface has Out Of Frame condition
ddsNetTimingSource: (read -write)
Allows you to select or verify the current timing source for the DDS network
interface. For the 41TDM in DDS-I or TXP-I mode, only ddsNetTimingNet and
ddsNetTimingInt apply. In DDS-II or TXP-II mode, only ddsNetTimingNet applies.
ddsNetTimingNet(1) - Unit dependent upon network for DDS network
interface timing