Verilink PRISM 41TDM (34-00275.4) Product Manual - Manual (Page 56)

48 C HAPTER 4: T ERMINAL I NTERFACE
System Location
This display accepts a character string of up to 58 characters identifying the
physical location of network device.
Management
Ports
The Management Ports screen (Figure 4-13) sets the following parameters for the
Call On Alarm (COA) connection on both the SUPV and SLIP ports.
Figure 4-13 Management Ports Screen
Element
This field allows reviewing and modifying the SUPV and SLIP port management
values for the near-end or far-end unit.
COA Connection (SUPV)
This field controls the remote alarm reporting. ASCII alarm reporting through the
supervisory port is independent of trap alarm reporting. The ASCII alarm report
type is set by the following choices:
Disabled - Alarm reporting is disabled.
Dial - Sends reports through an attached AT command set compatible modem
connected to the SUPV serial port, which must dial out to a remote modem.
The message format is described in the Element ID field.
Direct - Sends reports to a printer or terminal connected directly to the
supervisory port.
COA messages are reported in the following format in the DIAL or DIRECT
modes only:
Element ID
TxPORT DDS DSU Alarm Report MM/DD/YY HH:MM:SS
NET Alarms: alarms