Verilink NCM 2000 (880-502623-001) Product Manual - Manual (Page 82)

Downloading and Broadcasting Firmware
5-12 Verilink NCM 2000
Figure 5-9 DIDCSU Controller Administration Menu
From the DIDCSU Controller Administration Menu, select the
command option for: Y) switch over once
[1,6] DIDCSU 2912 > y
At the prompt select the partition:
Select image to switch to? 1) A 2) B > 2
NOTE: The firmware is always downloaded to the Bpartition.
The card reboots from the selected partition.
Confirming the Firmware Upgrade
A way to confirm the success of a firmware download is to use the
Administration Menu command option:
Q) query firmware
Figure 5-10 DIDCSU Administration Menu
Type the command:
[12.13.14.15] [1,6] DIDCSU 2912 > q
The query firmware report is displayed:
-- ACE CONTROLLER ADMINISTRATION MENU --
Date/Time/Zone: 8-14-96 20:02:41
Node Address: [12.13.14.15]
System uptime: 1:03:16
T) set time D) set date
Z) set time zone A) set node address
R) reset card P) change password
Q) query firmware I) change site name
O) switch over permanent Y) switchover once
F) restore card defaults X) main menu
[12.13.14.15] [1,6] DIDCSU >
-- ACE CONTROLLER ADMINISTRATION MENU --
Date/Time/Zone: 8-14-96 20:02:41
Node Address: [12.13.14.15]
System uptime: 1:03:16
T) set time D) set date
Z) set time zone A) set node address
R) reset card P) change password
Q) query firmware I) change site name
O) switch over permanent Y) switchover once
F) restore card defaults X) main menu
[12.13.14.15] [1,6] DIDCSU 2912 >