Verilink NCM 2000 (880-502623-001) Product Manual User Manual
Page 76
Downloading and Broadcasting Firmware
5-6
Verilink NCM 2000
If PING fails verify the TCP/IP related options. See
paying special attention to the Ethernet IP
address, Ethernet subnet mask and Ethernet type options. If the
address of the FTP server reflects a different network segment
than the NCM, also verify that the Gateway address reflects a valid
router port.
Once PING is successful, connect to the FTP server:
ftp 192.94.45.242
and then log in to the FTP server using whatever method your FTP
server package may require.
Navigate to the directory on the FTP server where you placed the
new download file. Typically this is done using the cd command:
cd mydir
Issue the binary command to set the transfer type to binary:
binary
Transfer the file to the NCM card by using the Get command:
get flash.qb flash.qb
NOTE: As with the copy command, the first instance of "flash.qb" in this
command is the source, the file on the FTP server, and the second
instance of "flash.qb" is the target or name under which it is to be
saved in RAM on the NCM. Be sure that you do save the file as
"flash.qb", regardless of its name on the FTP server.
You should see screen output like:
200 PORT command successful.
150 Binary data connection for flash.qb
(192.94.45.229,1026) (584121 bytes).
The file transfer is likely to take a few minutes, after which a
message appears:
226 Transfer complete.
584121 bytes received in 36 seconds (15 Kbytes/s)
Writing the File to
Flash Memory
Once the transfer is finished end your FTP session
quit
You will be returned to the pSH+> prompt.
Log in to the normal menu system
craft
At the shelf/slot map select:
O) administration