Performance and status, Performance and status -12 – Verilink NCM 2000 (880-502623-001) Product Manual User Manual

Page 36

Craft Interface

-12

Verilink NCM 2000

Figure 2-6 IMUX 2160 Diagnostics Menu

Performance and

Status

Performance and status functions are used to evaluate the
operation of application modules and the network facilities they
use. Modules which connect to network facilities such as E1, T1 or
T3 circuits will usually have statistics on circuit performance for
the preceeding 24 hours.

Performance and status for the NCM are not applicable, since the
NCM card does not connect to any customer equipment or circuits.

The performance information stored in each application module
module may be viewed by first selecting the module using the
shelf/slot command and then selecting P) performance/status.

[0.0.0.1] [1,13] IMUX 2160 > p

The Performance/Status Menu for an IMUX 2160 card is shown
below.

-- IMUX 2160 DIAGNOSTICS MENU --

Data Port Type: HSSI

Data Port Type: HSSI
DTR: YES

DTR: YES

DTR: YES
Loop type A: NO

Loop type A: NO

Loop type A: NO
Loop type B: NO

Loop type B: NO

Loop type B: NO
AIS Pattern: DISABLE

AIS Pattern: DISABLE

AIS Pattern: DISABLE
Test Pattern: DISABLE

Test Pattern: DISABLE

Test Pattern: DISABLE
Loopback: NONE

Loopback: NONE

Loopback: NONE
1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8
Lines Equipped: X X X X X X

Lines Equipped: X X X X X X

Lines Equipped: X X X X X X
Lines Active: X X X X X X

Lines Active: X X X X X X

Lines Active: X X X X X X
Frame Status: X X X X X X

Frame Status: X X X X X X

Frame Status: X X X X X X
CTS Status: X X X X X X

CTS Status: X X X X X X

CTS Status: X X X X X X
CRC Status:

CRC Status:

CRC Status:
Far CRC Status:

Far CRC Status:

Far CRC Status:
E) Equipment Loopback P) Payload Loopback

E) Equipment Loopback P) Payload Loopback

E) Equipment Loopback P) Payload Loopback
A) AIS Pattern X) main menu

A) AIS Pattern X) main menu

A) AIS Pattern X) main menu
[0.0.0.90] [1,13] IMUX 2160 >

[0.0.0.90] [1,13] IMUX 2160 >