Verilink NCM 2000 (880-502623-001) Product Manual - Manual (Page 81)

Downloading and Broadcasting Firmware
Verilink NCM 2000 5-11
Figure 5-8 NCM Broadcast Result
Press E NTER to display the NCM 2000 Download Firmware Menu.
If an ACP card did not receive a good load the Card Re-transmit
function may be used to specifically target that card.
Switching over to
the New
Firmware
Try the new firmware by using the B) ACP broadcast switchover
option.
NOTE: When switching over to the new firmware version, there is a slight
chance of failure to switch in one or a few modules. The user should
check that the switch-over is actually complete. If not, try again.
After a download, the target module cannot be downloaded again
until that module has been restarted (either in the A bank or in the
B bank).
NOTE: Do not attempt to do a switch over before the download has
completed. The card may be left in an inoperative condition.
Alternatively, the user may navigate to a specific card and reset it
individually, or use the switchover to bank B option.
From the Main Menu, select the module you wish to restart (in this
example, a DIDCSU module, which received the firmware
download):
[12.13.14.15] [1,1] NCM 2000 > s
You are prompted:
Enter ‘shelf,slot’ pair or ‘slot’ in current shelf(e.g. 3,4 or 5): > 1,6
The NCM Controller Main Menu appears:
Select the option for node administration: O
[12.13.14.15] [1,6] DIDCSU 2912 > o
The DIDCSU Controller Administration Menu appears:
<- SLOT ->
SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13
0 - - - - - - - - - - - - -
1 - - Y Y Y Y - - - - - - -
KEY:Y=GOOD, N=BAD
[12.13.14.15] [1,1] NCM 2000 >