Verilink NCM 2000 (880-502623-001) Product Manual - Manual (Page 41)

Craft Interface
Verilink NCM 2000 2-17
Card Specific
Menus
When the NCM is used to select certain application modules, new
commands and functions appear which are specific to those cards:
• When managing an HDM 2180 or HDM 2182 module the
prompt
F) Display Far End DS3 Port Identification appears .
This informational display will indicate:
• Equipment ID
• Location ID
• Frame ID
• Unit ID
• Facility ID
• Port ID
• Generator ID
• The HDM 2180 and HDM 2182 modules also present R) Remote
Setup which allows the user to configure certain far-end
parameters before inband management is enabled in the DS3
DSU. Before leaving this screen the fifth option Update NCM
Table should be used if any changes have been made. The
parameters which can be changed in the far-end DS3 product
are:
• Site name
• Node address
• Node ID
• Inband state
• Update NCM table (saves this info to node list)