beautypg.com

Ethernet and slip parameters, Ethernet and slip parameters -9 – Verilink NCM 2000 (880-502623-001) Product Manual User Manual

Page 51

background image

Administration Menu

Verilink NCM 2000

3-9

The network configuration parameters are standard Ethernet and
SLIP parameters. The user should consult with the system
administrators to obtain IP address information which is valid for
the local TCP/IP network.

Since the Ethernet IP address and SLIP IP address will be at a factory
default value in a new NCM module, it will always be necessary to
use the Craft interface L

OCAL

port at least once to set the Ethernet

and/or SLIP IP addresses. Thereafter, if desired, the Craft interface
can be accessed via Telnet over Ethernet or SLIP.

From the NCM Controller Administration menu, type “n” to access
the Network Configuration Menu:

NOTE: Upon entering a number of the routines under the Network

Configuration Menu, the user is advised that this will cause a reset

of the NCM in five minutes. This is done because the TCP/IP stack

runs at a level below the Craft interface. When changes are made to

the SNMP or other TCP/IP related functions, the NCM must be reset

before the changes take effect.

Figure 3-9 Network Configuration Menu

Ethernet and SLIP

Parameters

The parameter fields at the top of the Network Configuration
Menu reflect the values you enter using the menu commands at the
bottom of the menu.

I) ethernet ip address

Enter the Ethernet IP address of the primary NCM in the node, in
the form: [0.0.0.0]. for example: [192.94.45.242]

-- NETWORK CONFIGURATION MENU --

-- NETWORK CONFIGURATION MENU --

-- NETWORK CONFIGURATION MENU --

-- NETWORK CONFIGURATION MENU --
Ethernet Type: Ethernet 2

Ethernet Type: Ethernet 2

Ethernet Type: Ethernet 2

Ethernet Type: Ethernet 2
Enet IP Address/Subnet Mask: [192.94.45.242] / [255.255.255.0]

Enet IP Address/Subnet Mask: [192.94.45.242] / [255.255.255.0]

Enet IP Address/Subnet Mask: [192.94.45.242] / [255.255.255.0]

Enet IP Address/Subnet Mask: [192.94.45.242] / [255.255.255.0]
Gateway Address: [192.94.45.1]

Gateway Address: [192.94.45.1]

Gateway Address: [192.94.45.1]

Gateway Address: [192.94.45.1]
Ethernet Trap Addresses: [0.0.0.0] [0.0.0.0]

Ethernet Trap Addresses: [0.0.0.0] [0.0.0.0]

Ethernet Trap Addresses: [0.0.0.0] [0.0.0.0]

Ethernet Trap Addresses: [0.0.0.0] [0.0.0.0]
[0.0.0.0] [0.0.0.0]

[0.0.0.0] [0.0.0.0]

[0.0.0.0] [0.0.0.0]

[0.0.0.0] [0.0.0.0]
Slip IP Address/Subnet Mask: [192.94.46.100] / [255.255.255.0]

Slip IP Address/Subnet Mask: [192.94.46.100] / [255.255.255.0]

Slip IP Address/Subnet Mask: [192.94.46.100] / [255.255.255.0]

Slip IP Address/Subnet Mask: [192.94.46.100] / [255.255.255.0]
Slip Trap Addresses: [0.0.0.0] [0.0.0.0]

Slip Trap Addresses: [0.0.0.0] [0.0.0.0]

Slip Trap Addresses: [0.0.0.0] [0.0.0.0]

Slip Trap Addresses: [0.0.0.0] [0.0.0.0]
[0.0.0.0] [0.0.0.0]

[0.0.0.0] [0.0.0.0]

[0.0.0.0] [0.0.0.0]

[0.0.0.0] [0.0.0.0]
Read Community string: public

Read Community string: public

Read Community string: public

Read Community string: public
Write Community string: public

Write Community string: public

Write Community string: public

Write Community string: public

I) ethernet ip address L) slip ip address

I) ethernet ip address L) slip ip address

I) ethernet ip address L) slip ip address

I) ethernet ip address L) slip ip address
M) ethernet subnet mask S) slip subnet mask

M) ethernet subnet mask S) slip subnet mask

M) ethernet subnet mask S) slip subnet mask

M) ethernet subnet mask S) slip subnet mask
G) gateway ip address R) SNMP read community string

G) gateway ip address R) SNMP read community string

G) gateway ip address R) SNMP read community string

G) gateway ip address R) SNMP read community string
T) ethernet type W) SNMP write community string

T) ethernet type W) SNMP write community string

T) ethernet type W) SNMP write community string

T) ethernet type W) SNMP write community string
P) ethernet trap addresses E) slip trap addresses

P) ethernet trap addresses E) slip trap addresses

P) ethernet trap addresses E) slip trap addresses

P) ethernet trap addresses E) slip trap addresses
X) exit menu

X) exit menu

X) exit menu

X) exit menu
[0.0.0.5] [3,11] NCM 2000 >

[0.0.0.5] [3,11] NCM 2000 >

[0.0.0.5] [3,11] NCM 2000 >

[0.0.0.5] [3,11] NCM 2000 >