Verilink HDM 2180 (880-503048-001) Product Manual - Manual (Page 65)

Verilink HDM 2180 User Manual 5-1
Chapter
5
Standalone HDM 2180 SNMP
Management
NOTE: Before using SNMP, Telnet, FTP, or other TCP/IP protocol, you
must set your TCP/IP addresses first via the Craft interface of
whichever module is the “controlling module” for the shelf.
Use the Administration Menu to set the required TCP/IP
addresses.
Setting Up Your
TCP/IP
Addresses
Before using Telnet for the first time with an HDM 2180 module,
access the module locally via the Craft interface.
1. From the Main Menu, type O for the command:
O) node administration
The Administration Menu displays.
2. For a local Ethernet address, type the L command to get the
prompt to enter the address value:
L) Local IP Address
3. If using a router, you must enter the router’s IP address as the
gateway using
G) Local gateway IP address
4. If using SNMP Management, then enter the IP Address of the
SNMP Manager as
H) Management host IP address
5. The device to which alarm messages are to be sent, often the
same as above, is entered as
M) Management trap IP address
6. After these parameters have been set, reboot the module.
Now you can log in via Telnet.
NOTE: You must log out from a Telnet session if you want to use the
ASCII terminal interface via the Craft port.