Verilink HDM 2180 (880-503048-001) Product Manual - Manual (Page 47)

Verilink HDM 2180 User Manual 4-1
Chapter
4
HDM 2180 Management: Using NCM
2000
ASCII Access Settings
To access an HDM 2180 on the node from an ASCII terminal
connected to the Local port on an NCM 2000:
1. Ensure that your terminal parameters are set to the following
values:
• 19.2 kbit/s
• 8 data bits
• no parity
• one stop-bit
• no flow-control
Be sure that
X- ON
/
X- OFF
flow control is disabled.
2. Type “craft” and press E NTER .
3. At the
PASSWORD:
prompt, press E NTER .
Until you change the password, the E NTER key is the default
password. If you have changed the password or have been assigned
a password, type the correct password (up to 8 characters,
including spaces). The screen will display placeholders (
******
) as
you type the password. After typing the password, press E NTER .
The password of the NCM 2000 determines the level of access
available with the various functions of the HDM 2180. See the NCM
2000 User Manual for more information about this security feature.
NCM Controller Menu (Main Menu)
The NCM Controller Menu (Main Menu) displays the contents of
slots in the shelves of the selected node. This manual deals with
the HDM 2180 module in particular and the NCM module with
regard only to how the NCM module interacts with the HDM 2180
module. In the Main Menu:
• A T will display at the intersection of rows and columns that
designate the shelf/slot location of the HDM 2180 module.
• The letter N displays the NCM module locations.