Hssi port configuration menu, Hssi port configuration menu -7, Figure 4-5 – Verilink HDM 2180 (880-503048-001) Product Manual User Manual

Page 53

HDM 2180 Management: Using NCM 2000

Verilink HDM 2180 User Manual

4-7

HSSI Port

Configuration

Selecting H from the Configuration Menu displays the HSSI
Configuration Menu.

Figure 4-5 HDM 2180 HSSI Configuration Menu

Data Rate Mode—Determines whether data rate changes made at this end are

propagated to the remote DS3 module as well. Selecting both NE and FE is

suggested.

1) NE/FE

2) Only NE

Data Rate—The bandwidth which will be made available to the DTE on the

HSSI interface, expressed in increments of 1.6Mbit/s each. (21

1.6 = 33.6

Mbit/s). Enter a number within the range of 1 through 28. (28 represents

44.7 Mbit/s)

1—28

Equipment ID—An optional parameter. Enter up to 10 characters to describe

your DTE. It will also prompt if you want to clear the string.

Location ID—An optional parameter. Enter up to 11 characters to describe the

location of your DTE. It will also prompt if you want to clear the string.

Frame ID—An optional parameter. Enter up to 10 characters to define the

Frame ID. It will also prompt if you want to clear the string.

Unit ID—An optional parameter. Enter up to 6 characters to define the Unit ID.

It will also prompt if you want to clear the string.

Facility ID—An optional parameter. Enter up to 38 characters to define the

Facility ID. It will also prompt if you want to clear the string.

Port ID—An optional parameter. Enter up to 38 characters to define the Port

ID. It will also prompt if you want to clear the string.

Circuit ID—An optional parameter. Enter up to 26 characters to define the

Circuit ID. It will also prompt if you want to clear the string.

Test Sig ID—An optional parameter. Enter a single character to define the

Test Sig ID. It will also prompt if you want to clear the string.

Inband Control—This option toggles between Enable and Disable for the

FEAC (Far End Access and Control) test requests using the C-bit overhead.

1) Enable

2) Disable

Exit this screen—Returns you to the

HDM Configuration Menu

Figure

4-3

Command

Description

Options

-- HDM 2180 HSSI Configuration Menu --

Test Mode Disabled

P) Port Status OUT OF SERVICE

P) Port Status OUT OF SERVICE
M) Configuration Mode Manual

M) Configuration Mode Manual

M) Configuration Mode Manual
A) Data Scramble Disable

A) Data Scramble Disable

A) Data Scramble Disable
X) Exit this screen

X) Exit this screen

A [127.255.255.0] [1,6] HDM 2180 >