Verilink FrameStart FSD (34-00291.F) Product Manual - Manual (Page 37)

O p e r a t i o n 31
Enable Remote V54. As shown in Figure 4.12, the Enable Remote V54
forces the remote-end unit into a V54 loop. A BERT and a loop can only be
run simultaneously if the loop type is remote.
Figure 4.12 Enable Remote V.54
Enable Remote LLB (Line Loopback) (T1 CSU/DSU only). As shown in
Figure 4.13, the Enable Remote LLB forces the remote-end unit into a line
loopback. A BERT and a loop can only be run simultaneously if the loop type
is remote.
Figure 4.13 Enable Remote LLB
Enable Remote PLB (Payload Loopback) (T1 CSU/DSU only). As
shown in Figure 4.14, the Enable Remote PLB forces the remote-end unit into
a payload loopback. A remote PLB is only possible if the FDL mode is set to
AT&T or ANSI. A BERT and a loop can only be run simultaneously if the
loop type is remote.
Figure 4.14 Enable Remote PLB
BERT
This command allows selecting the BERT to run. The selections are as
follows.
None. No BERT selected.
Network Framer / Receivers/
BERT
DTE
From
NET
To
NET
To
Port
From
Port
(Winchester-type
Connector)
Drivers Deframer Interface
Generator/
Detector
To Network
RJ-48C
From Network
Network Framer / Receivers/
BERT
DTE
From
NET
To
NET
To
Port
From
Port
(Winchester-type
Connector)
Drivers Deframer Interface
Generator/
Detector
To Network
RJ-48C
From Network
Network Framer / Receivers/
BERT
DTE
From
NET
To
NET
To
Port
From
Port
(Winchester-type
Connector)
Drivers Deframer Interface
Generator/
Detector
To Network
RJ-48C
From Network