Verilink FrameStart FSD (34-00291.F) Product Manual - Manual (Page 27)

O p e r a t i o n 21
C H A P T E R
4
C HAPTER 4
O
PERATION
Introduction
This chapter describes the menus for the units’ operation.
Menu Start-up Display
The unit starts up with the menu display shown in Figure 4.1.
N (Network Status)
OK No alarms.
LS Loss of signal.
LI LMI Mode is Off.
LM The unit is in LMI Monitor mode.
NA Not available.
LD Loss of DTR.
RA Receiving yellow alarm, T1 CSU/DSU only.
LF Loss of frame (T1 CSU/DSU only).
D (DTE Status)
OK No problems.
LS Loss of Signal, when RTS and DTR are not present. When RTS and
DTR are lost, D intermediately toggles LD and LS for a few seconds
then settles on NA. When RTS and DTR are restored, NA takes up to
a minute to clear.
NA In FrameStart mode, the DTE is not available.
Figure 4.1 Start-Up Screen
FRAME START DDS
N:OK D:OK F:OK