Verilink FrameStart FSD (34-00291.F) Product Manual - Manual (Page 17)

I n s t a l l a t i o n 11
C H A P T E R
2
C HAPTER 2
I
NSTALLATION
Introduction
This chapter contains information and instructions required to prepare the
units for use. Included are initial inspection procedures, mounting instructions,
configuration guidelines, connection and powering information.
Safety Summary
This manual contains information and warnings that must be followed by the
user to ensure safe operation and to retain the equipment in a safe condition.
NOTICE: The WARNING sign denotes a potential hazard to the operator. It calls
attention to a procedure or practice that, if not correctly performed or
adhered to, could result in injury or loss of life. Do not proceed beyond a
WARNING sign until the indicated conditions are fully understood and
met.
Unpacking and Inspection
This unit is carefully packaged to prevent damage in shipment. Upon receipt,
inspect the shipping container for damage. If the shipping container or
cushioning material is damaged, notify the carrier immediately and make a
notation on the delivery receipt that the container was damaged (if possible,
obtain the signature and name of the person making delivery). Retain the
packaging material until the contents of the shipment have been checked for
completeness and the unit has been checked both mechanically and
electrically.
If the contents of the shipment are incomplete or, if there is mechanical
damage or defect, notify Verilink. If the shipping container is also damaged,
or the cushioning material shows signs of stress, notify the carrier of the
damage as well as Verilink. Keep the shipping materials for carrier’s