Printer configuration, Printer configuration -17 – Verilink AS100 (896-502379-001) Product Manual User Manual
Page 91

Access System Centum Series User Manual
6-17
Printer Configuration
To configure the SERIAL
1
Printer port, use the Centum Series control
panel to enter (
SELECT
) the Utilities menu. Use the
UP/DOWN
arrows
to locate NMS/Prt Port and the
SELECT
again. If necessary, use the
UP/
DOWN
arrows to locate Mode.
Repeatedly
SELECT
until the mode indicates Printer. Note that the
NMS function is not operational in this Centum Series revision.
Use the
UP
or
DOWN
arrow to display Speed and then
SELECT
to choose
the desired printer data rate. Finally,
END
twice to return to the Main
Menu.
The printer should be configured for the same data rate as the Centum
Series printer port and 8-N-1 character coding. All data is output with
both a CR and an LF at the end of each line. Printer “word wrap” is
unnecessary and the printer should not add an LF to each received CR.
1. This is a non-standard printer port. Most printers are parallel, not serial.