Verilink AS100 (896-502379-001) Product Manual - Manual (Page 76)

6-2 Access System Centum Series User Manual
Cabling
The table below provides a summary of the Verilink cables available for
the Centum series.
Table 6-1
For additional cable and pinout detail, see the following sections of this
manual:
■
Appendix B, Standard Cabling for User Ports
■
Appendix C, Special Serial Port Cabling.
Auxiliary ports Both auxiliary ports consist of 6-pin modular jacks. Because the ports are
permanently DCE, there are two configurations for the required cabling,
depending on whether the connections are “direct” or via modems.
Verilink Cable
Number Length Description Type of Cable
CBE 010-00001 15 ft. 8-pin to 8-pin modular Male-to-Male for network
connection
Networ
CBE 011-00001 15 ft. 8-pin to 8-pin modular Male-to-Male for equipment
connection
T1 Equipment
CBE 010-00002 4 ft. 6-pin modular to 25D-type Female for direct
connection
Management
458-502368-008 8 ft. 6-pin modular to 25D-type Male for modem connection Management
458-501983-015 15 ft. V.35 Male to Male, DCE to DTE Application
458-501792-015 15 ft. 25D-type with RS-530 specification. Male-to-Male Application
458-501776-015 15 ft. V.35 Male-to-Male for external timing a Application
458-501791-015 15 ft. RS-530 Male-to-Male for external timing a Application
Adapter Cables
b
(below)
458-502361-015 15 ft. 25D-type (RS-530) Male to 37-pin (RS-449) Female Application
458-502362-015 15 ft. 25D-type (RS-530) Male to 37-pin (RS-449) Male Application
458-502363-015 15 ft. 25D-type (RS-530) Male to 37-pin (RS-449) Female
for external timing
a
Application
458-502364-015 15 ft. 25D-type (RS-530) Male to 37-pin (RS-449) Male for
external timing a
Application
a. External Timing is the same as DSU-X, for a cross-over cable.
b. Adapter cables are used to convert between a 25-pin connector on the rear of the box to a 37-
pin connector on the customer apparatus.