Thinklogical Velocitykvm-4, 5, 8, 24, 28, 34, 35 & 38 Manual - Manual (Page 29)

V e l o c i t y K V M E x t e n d e r P r o d u c t M a n u a l , R e v . B , J a n u a r y , 2 0 1 4 Page 29
The VelocityKVM Extender menu functionality is as follows
(Some menu options may not be available on all models.):
TRANSMITTER:
Display Modifiable Description
*System
LS Connected
NO Indicates fiber status from TX to RX. (0=connected)
Tx Ctrl Name TX Only Name entered on TX unit is displayed on RX unit.
Load Defaults YES Loads factory default video configurations.
Store Values YES Store video configurations.
KM Device NO Revision of the VelocityKVM portion that plugs into CPU.
KM Remote Host NO Revision of the VelocityVKM Host on the RX unit.
KM Local Host NO Revision of the VelocityVKM Host on the TX unit.
TX Control NO Revision of the TX unit laser and front panel control.
RX Control NO Revision of the RX unit laser and front panel control.
FPGA Version NO Revision of the FPGA used for video generation.
Serial Number NO 2 digits: week, 2 digits: year, 2 to 4 digits unique unit number
Debug Values YES Factory Use.
Allow FPGA Update YES Select YES to enable update
Aud/USB Reset En YES Enable/disable USB 1.1 reset, lost Tx/Rx link
Des OK NO 1=Yes 0=No
SFP Loss of Signal NO Indicates loss of SFP signal. (1= not connected)
Temp in Celsius NO Tb=PCB temp (max=70) Tf=FPGA temp (max=85)
KMASS Card ID NO 0E = original, OC=SoDimm
Video Card ID NO 08=single 09=dual head 0A=dual link 0B=RGB
USB 2.0 Card ID NO 08=original 09=SoDimm
*DDC
DDC PROM Emula. Mode
YES Options are Dynamic, Static and Passthru.
In Dynamic mode, the EDID table* of the monitor connected to the
RX is read and stored on the TX. After any change in monitor type
a new EDID table will be stored on the TX. An EDID table is always
presented to the video source, whether the TX is ON or OFF.
Static mode is used to maintain the current EDID table regardless
of monitor changes at the RX. An EDID table is always presented to
the video source, whether the TX is ON or OFF.
Passthru mode makes the DDC pins look like direct connection
between the TX and RX, allowing the computer to talk directly to
the monitor.
Load Default DDC YES Loads the default EDID table* into the TX which allows 1024x768
and 1920x1200. This puts the TX into static mode.
Load 1080p YES Loads a widescreen version of the EDID table* into the TX.
Supported resolutions include 1920x1080 and 1280x720.
Acquire DDC YES Gets the EDID table* of the attached display, stores the information
on the TX, and puts the TX in static mode.
Force DDC Mode YES Used to force a monitor to appear as either digital or analog.
Since the Velocity products can convert between analog and
digital, sometimes the EDID table* has to be modified to match the
method of connecting the TX to CPU.
*See EDID Definitions and DDC Modes in Appendix F, page 60