Clone track, Clean out, Undoing operations – Teac DP-01 Series Owners Manual User Manual

Page 50: Clone track clean out, About track editing, Advanced techniques

About track editing

TASCAM DP-01

Owner’s Manual

Advanced techniques

CLONE TRACK

This copies a track or pair of tracks to another track or pair of tracks. The IN and
OUT points do not have any meaning here.

…

There are two values that you can change:

Src. Trk

Select an individual track (

through

), a pair of tracks (

1/2

3/4

5/6

7/8

) or the

MASTER

stereo track.

Dst. Trk

This sets the destination track or tracks to which the source track is

cloned. What you can select here depends on what you have selected for the
source track. If you have selected a single track, you can select tracks

through

here. If you have selected a pair of tracks (for instance,

1/2

), you can only

select track pairs here.

If you try to select
the same track as a

destination that you have se-
lected as the source, when you
press the

YES

key, a message will

appear.

Press

YES

to perform the operation or

to leave this screen.

Although you cannot mix the inputs to the

STEREO MIX

to the

mixed master track, you can add a drum machine (say) to the

mix in the following way:

• Mix down to the mix master track, using the

EFFECT SEND

and

EFFECT

RETURN

(“Mixdown and mastering” on page 23) to add reverb to your mix.

• Clone the stereo mix to a pair of tracks.
• Disconnect the drum machine from the

STEREO MIX

and connect it to the

RETURN

jacks. Make sure that it is set up to be synchronized to the DP-01

(“Working with MIDI” on page 35).

• Mix down again with only the two cloned tracks, using the

EFFECT

RETURN

control to add and adjust the level of the drum machine. You then

have a mix including the drum machine as well as the effect added to the
main tracks.

CLEAN OUT

This deletes all the material in a track or tracks. The IN and OUT points do not
have any meaning here.

…

There is only one value that you can change:

Src. Trk

Select an individual track (

through

), a pair of tracks (

1/2

3/4

5/6

7/8

), or all the tracks (

1-8

Press

YES

to perform the operation or

to leave this screen.

Undoing operations

If you have made a mistake on the DP-01, very often you can undo it! This
includes the track editing operations described here, as well as most other com-
mon operations you can perform (including recording).

…

Press the

UNDO

key briefly, to undo the last undoable action.

You must have
performed at least

one undoable action after switch-
ing on for the undo function to
work!

…

Press and hold the

UNDO

key for about a second, to show the

UNDO/

REDO

screen:

Figure 2.11: Cloning tracks

Figure 2.12: Cleaning out a

track

U N D O

R E D O

C O P Y

P A S T E

← 2

R E C O R D I N G

- S T A R T

U P -