Super Systems 3L Series - Manual (Page 50)

Operations Manual Series 3L
50
12.4 Calibration Parameters
The following table lists the parameters available in the Calibration List.
CALIBRATION PARAMETER LIST ‘cAL’
Name Scrolling
Display Parameter
Description Value Default Access
Level
U C A L USER
CALIBRATION To calibrate the 5
point linerization
table.
IDLE L3 only
PnT.1
PnT.2
PnT.3
PnT.4
PnT.5
rset
P H A S E CALIBRATION
PHASE To calibrate low
and high offset
Fact Return to factory settings Fact Factory
none Not selected none Conf only
0 Select mV i/p low calibration point
50 Select mV i/p high calibration point
0V Select V i/p low calibration point
150r Select PRT i/p low cal point
400r Select PRT i/p high cal point
CJC Select CJC calibration
G O CALIBRATION
START To start the
calibration
sequence NO Initial state NO Conf
Yes Start
Busy Calibrating
Pass Calibration successful
faiL Calibration unsuccessful
YES Start auto calibration
Lo These parameters automatically
appear as the calibration takes
place.
Hi
pass
faiL